This is 4 Hole version, if you need 2 Hole please leave us a message
AIR SCALER
Features
1.Appearance Beautiful and Hand feeling comfortable.
2.Wider Version and Operation Space due to smaller Body.
3.Less Pain than ultrasonic Scelar, more app;icable for pain sensitive patients.
4.Less heat generate during use so that less cooling water used and the version of dentist become clearer.
5.The movement track of scaler inserts is like shape of O ,more effective, could quickly eliminate the tartar, plaque and tea teeth, so not only less scratch and hurts on teeth surface but also no any hamful onto gums and teeth enamel.
6.Air drive, and directly connect onto 2/4 hole tube of dental unit, very easy to adjust the air pressure according to all kinds of your requirements.
7.Metal hadle ,disinfection durable at both high temperature 135℃ and high pressure 0.22MPa , effevtively aviod the cross infection.
8.No any tlectromagnetic radiation.
9.Compare to market level , the working noise level skip down and feels more comfortable.
10.With work tips changer, easy to Adaptive with EMS or other brand Work tips.
Parameters
Frequency :From 0 to 10000 Hz
Pressure: 0.24-0.32MPa(2.4-3.2kgf/cm2)
Air flow:4 hole-22L/Min 2 hole-23L/Min
Weight (exclude scaler insert) :4hole-66.2g 2hole-64g
Length (exclude scaler tips) :4hole-118.5mm 2hole-110mm
Cautions
1. The air supply must be free of moisture. The water supply must be filtered.
2. Place the most priority of the patients safety
3. Do not exceed 0.28Mpa(2.9kgf/cm2)when setting the air pressure at the dental unit.
4. If any abnormalities are found in use, stop using immediately and contact your dealer.
5. Do not drop, hit, or subject to excessive shocl.
6. Check the vibration, noise and overheating outside of the patient's mouth before initial use. If any abnormalities are found in use, stop using immediatel and contact your dealer.
7. Be sure to stop the air supply, and replace the tip ro the coupling joint.
8. Watch out the sharp point of the tip.
9. Do not use a spray lubricant. Limited air discharge orifice size of the scaler forces the propellant pressure to build up inside, and the scaler may fly off.
10. Do not clean or wipe the scaler with highly oxidized or acid water or strilizing solution.
Installation
1. Holding the tip-end, turn clockwise and fasten securely tighten with wrench.
2. Shout off the water supply. Adjust air pressure to 2.8KG/CM2 Adjust the water flow until a fine mist ejects from the tip.
Lubrication
Supply 2-3 drips into the drive air tube once or twice a day or spray lubricant into inlet hole of handpiece for about two seconds.
Content:
scaler handpiece * 1
work tips * 3
Wrench * 1
Ultrasonic Scaler Dental Supplies Dental Equipment